Arduino

Next Training Session

Date: Wednesday 16 November 2016
Time: 08:00pm – 10:00pm
Location: (Rangeview) Tolga, QLD
Cost: $90
Subject Arduino

Description

The Arduino Uno is a microcontroller board based on the ATmega328 microcontroller chip. It runs at a frequency of 16MHz, has 14 digital input/output pins, 6 analog inputs/outputs, a USB connection, a power jack, an ICSP programming header connector, and a reset button.

This 2 hour training session will teach you what you can do with an Arduino board, how to drive peripheral boards and components and how to use the Arduino software to program the device and run diagnostics using the serial monitor utility.

Lesson plan

The lesson plan covers the following activities:

  1. Introduction to Arduino microcontrollers.
  2. Introduction to Arduino software.
  3. Blinking a LED.
  4. Using the Serial Monitor.
  5. Blinking multiple LEDs using bitpatterns.
  6. Using a momentary pushbutton.
  7. Using servos.

Expressions of interest

Use the ‘Contact Us’ page to inquire about availability and to register for this course.  It is recommended to bring a computer, but if none available one will be provided.  Thank you for your interest.

Arduino was last modified: November 9th, 2016 by tabcom